SoapSender stripping out carriage returns

bbsaic · #1 10-17-2008, 08:08 AM

I have setup a channel. The source is a file. The Destination is a WebService using SoapSender. I am using version 1.7. I have tried so many different things for the past 2 days and can not get anything to work. The problem: When I set up the SoapSender I am sending an entire HL7 message to a webservice to have some fields changed and the response from the webservice is going to be a modified HL7 message. When I set the sender to send ${encoder.encode(${message.rawData})} my carriage returns get stripped out and line feeds are inserted. This causes problems when my webservice recieves it because it is expecting a HL7 spec message. Has anyone else run into this problem? If so I would appreciate any help you can give.

Thanks....

**jacobb** · #2 10-17-2008, 10:55 AM

Could you run this same test on the 1.8 RC to see if it still has the same problem? Thanks!

bbsaic · #3 10-20-2008, 08:22 AM

The same this happens in the latest release as well. The build I downloaded was mirth-1.8.0.3904.466-windows-installer.exe so now I am downloading mirth-1.8.0.3946.495-windows-installer.exe and will let you know on that version

Post edited by: bbsaic, at: 10/20/2008 09:44

bbsaic · #4 10-20-2008, 09:11 AM

Same problem with version 1.8.0.3946.495. Any other Ideas. Thanks for your help.

**jacobb** · #5 10-20-2008, 09:42 AM

Please create an issue in our issue tracker. Make sure to attach a sample message and sample channel with steps to reproduce the error. If you assign it to me for version 1.8 I will try to resolve it before the final 1.8 release.

bbsaic · #6 10-20-2008, 12:19 PM

I added it and it is MIRTH-948 but I was not able to put under your name.

**jacobb** · #7 10-20-2008, 12:21 PM

Thanks. I will take a look at it.

**jacobb** · #8 10-22-2008, 03:08 PM

The issue was what looked to be a typo in the Entity Encoder. I have resolved it, committed it, and it will be included in the next RC.

bbsaic · #9 10-23-2008, 05:36 AM

Do you happen to know when the next RC will be built? Just wanted to know so I could test it again.

Thanks again for all your help.

**jacobb** · #10 10-23-2008, 09:48 AM

Not sure right now. It will be posted in the sticky when it is out. Hopefully it won't be too far in the future.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Carriage return PDF and Text doc formatting	konstantin	Support	3	04-20-2013 03:15 PM
Mirth Output of new line and carriage return chars	pjzuber	Support	6	07-30-2010 12:20 PM
Messages coming in with Carriage Returns	Tireseus	Support	9	01-05-2009 10:42 AM
file writer strips out carriage returns	JasonGriffith	Support	2	06-24-2008 07:06 AM
Stripping / adding characters	arronramsey	Support	1	09-05-2007 01:21 PM