#1
|
|||
|
|||
![]()
I am new to this option and am trying to send to a registry. I have set up a destination with HTTP Sender and it looks like Attached item. The error I get back is as follows;
NACK sent from receiver. (Rejected) Access Denied Not sure what I am missing and could really use some help. Thanks Jeff |
#2
|
|||
|
|||
![]()
Sounds like an authentication error.
https://documentation.stchome.com/as..._Guide_PDF.pdf According to this, your parameters should be Code:
MESSAGEDATA USERID PASSWORD Code:
data Username Password |
#3
|
|||
|
|||
![]()
So I made those changes and still get the same error. Though every time the message does make it to the destination? Strangest thing. Thoughts?
|
#4
|
|||
|
|||
![]()
I would check with the registry and ask them what that error means and what you might need to change to fix it. It's hard to give advice when the requirements aren't clear.
|
#5
|
|||
|
|||
![]()
I agreed, but they seem to think it was the password. Though it is correct, we are just not sure where why. I have it listed correctly and verified the typing. I noticed that the destination is showing an issue with SSL, I don't have a certificate set up on this and could that be causing part of my problem?
|
#6
|
|||
|
|||
![]()
If you mean the little red X where you specify the URL, that's normal if you don't have the commercial SSL Manager plugin installed.
It sounds like you are getting the HL7 NACK as a response, and you have validate response set to yes in your screenshot, so that's probably what is causing the message to error, when the HTTP sender was technically successful (from what I can gather.) That at least also supports the idea that you don't have an SSL issue. |
![]() |
Thread Tools | |
Display Modes | |
|
|